sysfs-driver-hid-picolcd (1846B)
1What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/operation_mode 2Date: March 2010 3Contact: Bruno Prémont <bonbons@linux-vserver.org> 4Description: Make it possible to switch the PicoLCD device between LCD 5 (firmware) and bootloader (flasher) operation modes. 6 7 Reading: returns list of available modes, the active mode being 8 enclosed in brackets ('[' and ']') 9 10 Writing: causes operation mode switch. Permitted values are 11 the non-active mode names listed when read. 12 13 Note: when switching mode the current PicoLCD HID device gets 14 disconnected and reconnects after above delay (see attribute 15 operation_mode_delay for its value). 16 17 18What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/operation_mode_delay 19Date: April 2010 20Contact: Bruno Prémont <bonbons@linux-vserver.org> 21Description: Delay PicoLCD waits before restarting in new mode when 22 operation_mode has changed. 23 24 Reading/Writing: It is expressed in ms and permitted range is 25 0..30000ms. 26 27 28What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/fb_update_rate 29Date: March 2010 30Contact: Bruno Prémont <bonbons@linux-vserver.org> 31Description: Make it possible to adjust defio refresh rate. 32 33 Reading: returns list of available refresh rates (expressed in Hz), 34 the active refresh rate being enclosed in brackets ('[' and ']') 35 36 Writing: accepts new refresh rate expressed in integer Hz 37 within permitted rates. 38 39 Note: As device can barely do 2 complete refreshes a second 40 it only makes sense to adjust this value if only one or two 41 tiles get changed and it's not appropriate to expect the application 42 to flush its tiny changes explicitly at higher than default rate. 43