init.rst (2613B)
1Explaining the "No working init found." boot hang message 2========================================================= 3:Authors: Andreas Mohr <andi at lisas period de> 4 Cristian Souza <cristianmsbr at gmail period com> 5 6This document provides some high-level reasons for failure 7(listed roughly in order of execution) to load the init binary. 8 91) **Unable to mount root FS**: Set "debug" kernel parameter (in bootloader 10 config file or CONFIG_CMDLINE) to get more detailed kernel messages. 11 122) **init binary doesn't exist on rootfs**: Make sure you have the correct 13 root FS type (and ``root=`` kernel parameter points to the correct 14 partition), required drivers such as storage hardware (such as SCSI or 15 USB!) and filesystem (ext3, jffs2, etc.) are builtin (alternatively as 16 modules, to be pre-loaded by an initrd). 17 183) **Broken console device**: Possibly a conflict in ``console= setup`` 19 --> initial console unavailable. E.g. some serial consoles are unreliable 20 due to serial IRQ issues (e.g. missing interrupt-based configuration). 21 Try using a different ``console= device`` or e.g. ``netconsole=``. 22 234) **Binary exists but dependencies not available**: E.g. required library 24 dependencies of the init binary such as ``/lib/ld-linux.so.2`` missing or 25 broken. Use ``readelf -d <INIT>|grep NEEDED`` to find out which libraries 26 are required. 27 285) **Binary cannot be loaded**: Make sure the binary's architecture matches 29 your hardware. E.g. i386 vs. x86_64 mismatch, or trying to load x86 on ARM 30 hardware. In case you tried loading a non-binary file here (shell script?), 31 you should make sure that the script specifies an interpreter in its 32 shebang header line (``#!/...``) that is fully working (including its 33 library dependencies). And before tackling scripts, better first test a 34 simple non-script binary such as ``/bin/sh`` and confirm its successful 35 execution. To find out more, add code ``to init/main.c`` to display 36 kernel_execve()s return values. 37 38Please extend this explanation whenever you find new failure causes 39(after all loading the init binary is a CRITICAL and hard transition step 40which needs to be made as painless as possible), then submit a patch to LKML. 41Further TODOs: 42 43- Implement the various ``run_init_process()`` invocations via a struct array 44 which can then store the ``kernel_execve()`` result value and on failure 45 log it all by iterating over **all** results (very important usability fix). 46- Try to make the implementation itself more helpful in general, e.g. by 47 providing additional error messages at affected places. 48