st,flexgen.txt (5464B)
1Binding for a type of flexgen structure found on certain 2STMicroelectronics consumer electronics SoC devices 3 4This structure includes: 5- a clock cross bar (represented by a mux element) 6- a pre and final dividers (represented by a divider and gate elements) 7 8Flexgen structure is a part of Clockgen[1]. 9 10Please find an example below: 11 12 Clockgen block diagram 13 ------------------------------------------------------------------- 14 | Flexgen structure | 15 | --------------------------------------------- | 16 | | ------- -------- -------- | | 17clk_sysin | | | | | | | | | 18---|-----------------|-->| | | | | | | | 19 | | | | | | | | | | | 20 | | ------- | | | |Pre | |Final | | | 21 | | |PLL0 | | | | |Dividers| |Dividers| | | 22 | |->| | | | | | x32 | | x32 | | | 23 | | | odf_0|----|-->| | | | | | | | 24 | | | | | | | | | | | | | 25 | | | | | | | | | | | | | 26 | | | | | | | | | | | | | 27 | | | | | | | | | | | | | 28 | | ------- | | | | | | | | | 29 | | | | | | | | | | | 30 | | ------- | | Clock | | | | | | | 31 | | |PLL1 | | | | | | | | | | 32 | |->| | | | Cross | | | | | | | 33 | | | odf_0|----|-->| | | | | | CLK_DIV[31:0] 34 | | | | | | Bar |====>| |====>| |===|=========> 35 | | | | | | | | | | | | | 36 | | | | | | | | | | | | | 37 | | | | | | | | | | | | | 38 | | ------- | | | | | | | | | 39 | | | | | | | | | | | 40 | | ------- | | | | | | | | | 41 | | |QUADFS | | | | | | | | | | 42 | |->| ch0|----|-->| | | | | | | | 43 | | | | | | | | | | | | 44 | | ch1|----|-->| | | | | | | | 45 | | | | | | | | | | | | 46 | | ch2|----|-->| | | DIV | | DIV | | | 47 | | | | | | | 1 to | | 1 to | | | 48 | | ch3|----|-->| | | 1024 | | 64 | | | 49 | ------- | | | | | | | | | 50 | | ------- -------- -------- | | 51 | -------------------------------------------- | 52 | | 53 ------------------------------------------------------------------- 54 55This binding uses the common clock binding[2]. 56 57[1] Documentation/devicetree/bindings/clock/st/st,clkgen.txt 58[2] Documentation/devicetree/bindings/clock/clock-bindings.txt 59 60Required properties: 61- compatible : shall be: 62 "st,flexgen" 63 "st,flexgen-audio", "st,flexgen" (enable clock propagation on parent for 64 audio use case) 65 "st,flexgen-video", "st,flexgen" (enable clock propagation on parent 66 and activate synchronous mode) 67 "st,flexgen-stih407-a0" 68 "st,flexgen-stih410-a0" 69 "st,flexgen-stih407-c0" 70 "st,flexgen-stih410-c0" 71 "st,flexgen-stih418-c0" 72 "st,flexgen-stih407-d0" 73 "st,flexgen-stih410-d0" 74 "st,flexgen-stih407-d2" 75 "st,flexgen-stih418-d2" 76 "st,flexgen-stih407-d3" 77 78- #clock-cells : from common clock binding; shall be set to 1 (multiple clock 79 outputs). 80 81- clocks : must be set to the parent's phandle. it's could be output clocks of 82 a quadsfs or/and a pll or/and clk_sysin (up to 7 clocks) 83 84- clock-output-names : List of strings used to name the clock outputs. 85 86Example: 87 88 clk_s_c0_flexgen: clk-s-c0-flexgen { 89 90 #clock-cells = <1>; 91 compatible = "st,flexgen"; 92 93 clocks = <&clk_s_c0_pll0 0>, 94 <&clk_s_c0_pll1 0>, 95 <&clk_s_c0_quadfs 0>, 96 <&clk_s_c0_quadfs 1>, 97 <&clk_s_c0_quadfs 2>, 98 <&clk_s_c0_quadfs 3>, 99 <&clk_sysin>; 100 101 clock-output-names = "clk-icn-gpu", 102 "clk-fdma", 103 "clk-nand", 104 "clk-hva", 105 "clk-proc-stfe", 106 "clk-proc-tp", 107 "clk-rx-icn-dmu", 108 "clk-rx-icn-hva", 109 "clk-icn-cpu", 110 "clk-tx-icn-dmu", 111 "clk-mmc-0", 112 "clk-mmc-1", 113 "clk-jpegdec", 114 "clk-ext2fa9", 115 "clk-ic-bdisp-0", 116 "clk-ic-bdisp-1", 117 "clk-pp-dmu", 118 "clk-vid-dmu", 119 "clk-dss-lpc", 120 "clk-st231-aud-0", 121 "clk-st231-gp-1", 122 "clk-st231-dmu", 123 "clk-icn-lmi", 124 "clk-tx-icn-disp-1", 125 "clk-icn-sbc", 126 "clk-stfe-frc2", 127 "clk-eth-phy", 128 "clk-eth-ref-phyclk", 129 "clk-flash-promip", 130 "clk-main-disp", 131 "clk-aux-disp", 132 "clk-compo-dvp"; 133 };