imx290.txt (1785B)
1* Sony IMX290 1/2.8-Inch CMOS Image Sensor 2 3The Sony IMX290 is a 1/2.8-Inch CMOS Solid-state image sensor with 4Square Pixel for Color Cameras. It is programmable through I2C and 4-wire 5interfaces. The sensor output is available via CMOS logic parallel SDR output, 6Low voltage LVDS DDR output and CSI-2 serial data output. The CSI-2 bus is the 7default. No bindings have been defined for the other busses. 8 9Required Properties: 10- compatible: Should be "sony,imx290" 11- reg: I2C bus address of the device 12- clocks: Reference to the xclk clock. 13- clock-names: Should be "xclk". 14- clock-frequency: Frequency of the xclk clock in Hz. 15- vdddo-supply: Sensor digital IO regulator. 16- vdda-supply: Sensor analog regulator. 17- vddd-supply: Sensor digital core regulator. 18 19Optional Properties: 20- reset-gpios: Sensor reset GPIO 21 22The imx290 device node should contain one 'port' child node with 23an 'endpoint' subnode. For further reading on port node refer to 24Documentation/devicetree/bindings/media/video-interfaces.txt. 25 26Required Properties on endpoint: 27- data-lanes: check ../video-interfaces.txt 28- link-frequencies: check ../video-interfaces.txt 29- remote-endpoint: check ../video-interfaces.txt 30 31Example: 32 &i2c1 { 33 ... 34 imx290: camera-sensor@1a { 35 compatible = "sony,imx290"; 36 reg = <0x1a>; 37 38 reset-gpios = <&msmgpio 35 GPIO_ACTIVE_LOW>; 39 pinctrl-names = "default"; 40 pinctrl-0 = <&camera_rear_default>; 41 42 clocks = <&gcc GCC_CAMSS_MCLK0_CLK>; 43 clock-names = "xclk"; 44 clock-frequency = <37125000>; 45 46 vdddo-supply = <&camera_vdddo_1v8>; 47 vdda-supply = <&camera_vdda_2v8>; 48 vddd-supply = <&camera_vddd_1v5>; 49 50 port { 51 imx290_ep: endpoint { 52 data-lanes = <1 2 3 4>; 53 link-frequencies = /bits/ 64 <445500000>; 54 remote-endpoint = <&csiphy0_ep>; 55 }; 56 }; 57 };