btusb.txt (1384B)
1Generic Bluetooth controller over USB (btusb driver) 2--------------------------------------------------- 3 4Required properties: 5 6 - compatible : should comply with the format "usbVID,PID" specified in 7 Documentation/devicetree/bindings/usb/usb-device.yaml 8 At the time of writing, the only OF supported devices 9 (more may be added later) are: 10 11 "usb1286,204e" (Marvell 8997) 12 "usbcf3,e300" (Qualcomm QCA6174A) 13 "usb4ca,301a" (Qualcomm QCA6174A (Lite-On)) 14 15 16Also, vendors that use btusb may have device additional properties, e.g: 17Documentation/devicetree/bindings/net/marvell-bt-8xxx.txt 18 19Optional properties: 20 21 - interrupt-names: (see below) 22 - interrupts : The interrupt specified by the name "wakeup" is the interrupt 23 that shall be used for out-of-band wake-on-bt. Driver will 24 request this interrupt for wakeup. During system suspend, the 25 irq will be enabled so that the bluetooth chip can wakeup host 26 platform out of band. During system resume, the irq will be 27 disabled to make sure unnecessary interrupt is not received. 28 29Example: 30 31Following example uses irq pin number 3 of gpio0 for out of band wake-on-bt: 32 33&usb_host1_ehci { 34 #address-cells = <1>; 35 #size-cells = <0>; 36 37 mvl_bt1: bt@1 { 38 compatible = "usb1286,204e"; 39 reg = <1>; 40 interrupt-parent = <&gpio0>; 41 interrupt-names = "wakeup"; 42 interrupts = <3 IRQ_TYPE_LEVEL_LOW>; 43 }; 44};