altera-pcie.txt (1866B)
1* Altera PCIe controller 2 3Required properties: 4- compatible : should contain "altr,pcie-root-port-1.0" or "altr,pcie-root-port-2.0" 5- reg: a list of physical base address and length for TXS and CRA. 6 For "altr,pcie-root-port-2.0", additional HIP base address and length. 7- reg-names: must include the following entries: 8 "Txs": TX slave port region 9 "Cra": Control register access region 10 "Hip": Hard IP region (if "altr,pcie-root-port-2.0") 11- interrupts: specifies the interrupt source of the parent interrupt 12 controller. The format of the interrupt specifier depends 13 on the parent interrupt controller. 14- device_type: must be "pci" 15- #address-cells: set to <3> 16- #size-cells: set to <2> 17- #interrupt-cells: set to <1> 18- ranges: describes the translation of addresses for root ports and 19 standard PCI regions. 20- interrupt-map-mask and interrupt-map: standard PCI properties to define the 21 mapping of the PCIe interface to interrupt numbers. 22 23Optional properties: 24- msi-parent: Link to the hardware entity that serves as the MSI controller 25 for this PCIe controller. 26- bus-range: PCI bus numbers covered 27 28Example 29 pcie_0: pcie@c00000000 { 30 compatible = "altr,pcie-root-port-1.0"; 31 reg = <0xc0000000 0x20000000>, 32 <0xff220000 0x00004000>; 33 reg-names = "Txs", "Cra"; 34 interrupt-parent = <&hps_0_arm_gic_0>; 35 interrupts = <0 40 4>; 36 interrupt-controller; 37 #interrupt-cells = <1>; 38 bus-range = <0x0 0xFF>; 39 device_type = "pci"; 40 msi-parent = <&msi_to_gic_gen_0>; 41 #address-cells = <3>; 42 #size-cells = <2>; 43 interrupt-map-mask = <0 0 0 7>; 44 interrupt-map = <0 0 0 1 &pcie_0 1>, 45 <0 0 0 2 &pcie_0 2>, 46 <0 0 0 3 &pcie_0 3>, 47 <0 0 0 4 &pcie_0 4>; 48 ranges = <0x82000000 0x00000000 0x00000000 0xc0000000 0x00000000 0x10000000 49 0x82000000 0x00000000 0x10000000 0xd0000000 0x00000000 0x10000000>; 50 };