mvebu-uart.txt (2510B)
1* Marvell UART : Non standard UART used in some of Marvell EBU SoCs 2 e.g., Armada-3700. 3 4Required properties: 5- compatible: 6 - "marvell,armada-3700-uart" for the standard variant of the UART 7 (32 bytes FIFO, no DMA, level interrupts, 8-bit access to the 8 FIFO), called also UART1. 9 - "marvell,armada-3700-uart-ext" for the extended variant of the 10 UART (128 bytes FIFO, DMA, front interrupts, 8-bit or 32-bit 11 accesses to the FIFO), called also UART2. 12- reg: offset and length of the register set for the device. 13- clocks: UART reference clock used to derive the baudrate. If no clock 14 is provided (possible only with the "marvell,armada-3700-uart" 15 compatible string for backward compatibility), it will only work 16 if the baudrate was initialized by the bootloader and no baudrate 17 change will then be possible. When provided it should be UART1-clk 18 for standard variant of UART and UART2-clk for extended variant 19 of UART. TBG clock (with UART TBG divisors d1=d2=1) or xtal clock 20 should not be used and are supported only for backward compatibility. 21- interrupts: 22 - Must contain three elements for the standard variant of the IP 23 (marvell,armada-3700-uart): "uart-sum", "uart-tx" and "uart-rx", 24 respectively the UART sum interrupt, the UART TX interrupt and 25 UART RX interrupt. A corresponding interrupt-names property must 26 be defined. 27 - Must contain two elements for the extended variant of the IP 28 (marvell,armada-3700-uart-ext): "uart-tx" and "uart-rx", 29 respectively the UART TX interrupt and the UART RX interrupt. A 30 corresponding interrupt-names property must be defined. 31 - For backward compatibility reasons, a single element interrupts 32 property is also supported for the standard variant of the IP, 33 containing only the UART sum interrupt. This form is deprecated 34 and should no longer be used. 35 36Example: 37 uart0: serial@12000 { 38 compatible = "marvell,armada-3700-uart"; 39 reg = <0x12000 0x18>; 40 clocks = <&uartclk 0>; 41 interrupts = 42 <GIC_SPI 11 IRQ_TYPE_LEVEL_HIGH>, 43 <GIC_SPI 12 IRQ_TYPE_LEVEL_HIGH>, 44 <GIC_SPI 13 IRQ_TYPE_LEVEL_HIGH>; 45 interrupt-names = "uart-sum", "uart-tx", "uart-rx"; 46 }; 47 48 uart1: serial@12200 { 49 compatible = "marvell,armada-3700-uart-ext"; 50 reg = <0x12200 0x30>; 51 clocks = <&uartclk 1>; 52 interrupts = 53 <GIC_SPI 30 IRQ_TYPE_EDGE_RISING>, 54 <GIC_SPI 31 IRQ_TYPE_EDGE_RISING>; 55 interrupt-names = "uart-tx", "uart-rx"; 56 };