cs43130.txt (1970B)
1CS43130 DAC 2 3Required properties: 4 5 - compatible : "cirrus,cs43130", "cirrus,cs4399", "cirrus,cs43131", 6 "cirrus,cs43198" 7 8 - reg : the I2C address of the device for I2C 9 10 - VA-supply, VP-supply, VL-supply, VCP-supply, VD-supply: 11 power supplies for the device, as covered in 12 Documentation/devicetree/bindings/regulator/regulator.txt. 13 14 15Optional properties: 16 17 - reset-gpios : Active low GPIO used to reset the device 18 19 - cirrus,xtal-ibias: 20 When external MCLK is generated by external crystal 21 oscillator, CS43130 can be used to provide bias current 22 for external crystal. Amount of bias current sent is 23 set as: 24 1 = 7.5uA 25 2 = 12.5uA 26 3 = 15uA 27 28 - cirrus,dc-measure: 29 Boolean, define to enable headphone DC impedance measurement. 30 31 - cirrus,ac-measure: 32 Boolean, define to enable headphone AC impedance measurement. 33 DC impedance must also be enabled for AC impedance measurement. 34 35 - cirrus,dc-threshold: 36 Define 2 DC impedance thresholds in ohms for HP output control. 37 Default values are 50 and 120 Ohms. 38 39 - cirrus,ac-freq: 40 Define the frequencies at which to measure HP AC impedance. 41 Only used if "cirrus,dc-measure" is defined. 42 Exactly 10 frequencies must be defined. 43 If this properties is undefined, by default, 44 following frequencies are used: 45 <24 43 93 200 431 928 2000 4309 9283 20000> 46 The above frequencies are logarithmically equally spaced. 47 Log base is 10. 48 49Example: 50 51cs43130: audio-codec@30 { 52 compatible = "cirrus,cs43130"; 53 reg = <0x30>; 54 reset-gpios = <&axi_gpio 54 0>; 55 VA-supply = <&dummy_vreg>; 56 VP-supply = <&dummy_vreg>; 57 VL-supply = <&dummy_vreg>; 58 VCP-supply = <&dummy_vreg>; 59 VD-supply = <&dummy_vreg>; 60 cirrus,xtal-ibias = <2>; 61 interrupt-parent = <&gpio0>; 62 interrupts = <55 8>; 63 cirrus,dc-measure; 64 cirrus,ac-measure; 65 cirrus,dc-threshold = /bits/ 16 <20 100>; 66 cirrus,ac-freq = /bits/ 16 <24 43 93 200 431 928 2000 4309 9283 20000>; 67};