rt5677.txt (1902B)
1RT5677 audio CODEC 2 3This device supports I2C only. 4 5Required properties: 6 7- compatible : "realtek,rt5677". 8 9- reg : The I2C address of the device. 10 11- interrupts : The CODEC's interrupt output. 12 13- gpio-controller : Indicates this device is a GPIO controller. 14 15- #gpio-cells : Should be two. The first cell is the pin number and the 16 second cell is used to specify optional parameters (currently unused). 17 18Optional properties: 19 20- realtek,pow-ldo2-gpio : The GPIO that controls the CODEC's POW_LDO2 pin. 21- realtek,reset-gpio : The GPIO that controls the CODEC's RESET pin. Active low. 22 23- realtek,in1-differential 24- realtek,in2-differential 25- realtek,lout1-differential 26- realtek,lout2-differential 27- realtek,lout3-differential 28 Boolean. Indicate MIC1/2 input and LOUT1/2/3 outputs are differential, 29 rather than single-ended. 30 31- realtek,gpio-config 32 Array of six 8bit elements that configures GPIO. 33 0 - floating (reset value) 34 1 - pull down 35 2 - pull up 36 37- realtek,jd1-gpio 38 Configures GPIO Mic Jack detection 1. 39 Select 0 ~ 3 as OFF, GPIO1, GPIO2 and GPIO3 respectively. 40 41- realtek,jd2-gpio 42- realtek,jd3-gpio 43 Configures GPIO Mic Jack detection 2 and 3. 44 Select 0 ~ 3 as OFF, GPIO4, GPIO5 and GPIO6 respectively. 45 46Pins on the device (for linking into audio routes): 47 48 * IN1P 49 * IN1N 50 * IN2P 51 * IN2N 52 * MICBIAS1 53 * DMIC1 54 * DMIC2 55 * DMIC3 56 * DMIC4 57 * LOUT1 58 * LOUT2 59 * LOUT3 60 61Example: 62 63rt5677 { 64 compatible = "realtek,rt5677"; 65 reg = <0x2c>; 66 interrupt-parent = <&gpio>; 67 interrupts = <TEGRA_GPIO(W, 3) IRQ_TYPE_LEVEL_HIGH>; 68 69 gpio-controller; 70 #gpio-cells = <2>; 71 72 realtek,pow-ldo2-gpio = 73 <&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>; 74 realtek,reset-gpio = <&gpio TEGRA_GPIO(BB, 3) GPIO_ACTIVE_LOW>; 75 realtek,in1-differential = "true"; 76 realtek,gpio-config = /bits/ 8 <0 0 0 0 0 2>; /* pull up GPIO6 */ 77 realtek,jd2-gpio = <3>; /* Enables Jack detection for GPIO6 */ 78};