imx53-mba53.dts (5392B)
1// SPDX-License-Identifier: GPL-2.0-or-later 2/* 3 * Copyright 2012 Sascha Hauer <s.hauer@pengutronix.de>, Pengutronix 4 * Copyright 2012 Steffen Trumtrar <s.trumtrar@pengutronix.de>, Pengutronix 5 */ 6 7/dts-v1/; 8#include "imx53-tqma53.dtsi" 9 10/ { 11 model = "TQ MBa53 starter kit"; 12 compatible = "tq,mba53", "tq,tqma53", "fsl,imx53"; 13 14 chosen { 15 stdout-path = &uart2; 16 }; 17 18 backlight { 19 compatible = "pwm-backlight"; 20 pwms = <&pwm2 0 50000>; 21 brightness-levels = <0 24 28 32 36 40 44 48 52 56 60 64 68 72 76 80 84 88 92 96 100>; 22 default-brightness-level = <10>; 23 enable-gpios = <&gpio7 7 0>; 24 power-supply = <®_backlight>; 25 }; 26 27 disp1: disp1 { 28 compatible = "fsl,imx-parallel-display"; 29 pinctrl-names = "default"; 30 pinctrl-0 = <&pinctrl_disp1_1>; 31 interface-pix-fmt = "rgb24"; 32 status = "disabled"; 33 34 port { 35 display1_in: endpoint { 36 remote-endpoint = <&ipu_di1_disp1>; 37 }; 38 }; 39 }; 40 41 regulators { 42 compatible = "simple-bus"; 43 #address-cells = <1>; 44 #size-cells = <0>; 45 46 reg_backlight: regulator@0 { 47 compatible = "regulator-fixed"; 48 reg = <0>; 49 regulator-name = "lcd-supply"; 50 gpio = <&gpio2 5 0>; 51 startup-delay-us = <5000>; 52 }; 53 54 reg_3p2v: regulator@1 { 55 compatible = "regulator-fixed"; 56 reg = <1>; 57 regulator-name = "3P2V"; 58 regulator-min-microvolt = <3200000>; 59 regulator-max-microvolt = <3200000>; 60 regulator-always-on; 61 }; 62 }; 63 64 sound { 65 compatible = "tq,imx53-mba53-sgtl5000", 66 "fsl,imx-audio-sgtl5000"; 67 model = "imx53-mba53-sgtl5000"; 68 ssi-controller = <&ssi2>; 69 audio-codec = <&codec>; 70 audio-routing = 71 "MIC_IN", "Mic Jack", 72 "Mic Jack", "Mic Bias", 73 "Headphone Jack", "HP_OUT"; 74 mux-int-port = <2>; 75 mux-ext-port = <5>; 76 }; 77}; 78 79&ldb { 80 pinctrl-names = "default"; 81 pinctrl-0 = <&pinctrl_lvds1_1>; 82 status = "disabled"; 83}; 84 85&iomuxc { 86 lvds1 { 87 pinctrl_lvds1_1: lvds1-grp1 { 88 fsl,pins = < 89 MX53_PAD_LVDS0_TX3_P__LDB_LVDS0_TX3 0x80000000 90 MX53_PAD_LVDS0_CLK_P__LDB_LVDS0_CLK 0x80000000 91 MX53_PAD_LVDS0_TX2_P__LDB_LVDS0_TX2 0x80000000 92 MX53_PAD_LVDS0_TX1_P__LDB_LVDS0_TX1 0x80000000 93 MX53_PAD_LVDS0_TX0_P__LDB_LVDS0_TX0 0x80000000 94 >; 95 }; 96 97 pinctrl_lvds1_2: lvds1-grp2 { 98 fsl,pins = < 99 MX53_PAD_LVDS1_TX3_P__LDB_LVDS1_TX3 0x80000000 100 MX53_PAD_LVDS1_TX2_P__LDB_LVDS1_TX2 0x80000000 101 MX53_PAD_LVDS1_CLK_P__LDB_LVDS1_CLK 0x80000000 102 MX53_PAD_LVDS1_TX1_P__LDB_LVDS1_TX1 0x80000000 103 MX53_PAD_LVDS1_TX0_P__LDB_LVDS1_TX0 0x80000000 104 >; 105 }; 106 }; 107 108 disp1 { 109 pinctrl_disp1_1: disp1-grp1 { 110 fsl,pins = < 111 MX53_PAD_EIM_A16__IPU_DI1_DISP_CLK 0x80000000 /* DISP1_CLK */ 112 MX53_PAD_EIM_DA10__IPU_DI1_PIN15 0x80000000 /* DISP1_DRDY */ 113 MX53_PAD_EIM_D23__IPU_DI1_PIN2 0x80000000 /* DISP1_HSYNC */ 114 MX53_PAD_EIM_EB3__IPU_DI1_PIN3 0x80000000 /* DISP1_VSYNC */ 115 MX53_PAD_EIM_D26__IPU_DISP1_DAT_22 0x80000000 116 MX53_PAD_EIM_D27__IPU_DISP1_DAT_23 0x80000000 117 MX53_PAD_EIM_D30__IPU_DISP1_DAT_21 0x80000000 118 MX53_PAD_EIM_D31__IPU_DISP1_DAT_20 0x80000000 119 MX53_PAD_EIM_A24__IPU_DISP1_DAT_19 0x80000000 120 MX53_PAD_EIM_A23__IPU_DISP1_DAT_18 0x80000000 121 MX53_PAD_EIM_A22__IPU_DISP1_DAT_17 0x80000000 122 MX53_PAD_EIM_A21__IPU_DISP1_DAT_16 0x80000000 123 MX53_PAD_EIM_A20__IPU_DISP1_DAT_15 0x80000000 124 MX53_PAD_EIM_A19__IPU_DISP1_DAT_14 0x80000000 125 MX53_PAD_EIM_A18__IPU_DISP1_DAT_13 0x80000000 126 MX53_PAD_EIM_A17__IPU_DISP1_DAT_12 0x80000000 127 MX53_PAD_EIM_EB0__IPU_DISP1_DAT_11 0x80000000 128 MX53_PAD_EIM_EB1__IPU_DISP1_DAT_10 0x80000000 129 MX53_PAD_EIM_DA0__IPU_DISP1_DAT_9 0x80000000 130 MX53_PAD_EIM_DA1__IPU_DISP1_DAT_8 0x80000000 131 MX53_PAD_EIM_DA2__IPU_DISP1_DAT_7 0x80000000 132 MX53_PAD_EIM_DA3__IPU_DISP1_DAT_6 0x80000000 133 MX53_PAD_EIM_DA4__IPU_DISP1_DAT_5 0x80000000 134 MX53_PAD_EIM_DA5__IPU_DISP1_DAT_4 0x80000000 135 MX53_PAD_EIM_DA6__IPU_DISP1_DAT_3 0x80000000 136 MX53_PAD_EIM_DA7__IPU_DISP1_DAT_2 0x80000000 137 MX53_PAD_EIM_DA8__IPU_DISP1_DAT_1 0x80000000 138 MX53_PAD_EIM_DA9__IPU_DISP1_DAT_0 0x80000000 139 >; 140 }; 141 }; 142 143 tve { 144 pinctrl_vga_sync_1: vgasync-grp1 { 145 fsl,pins = < 146 /* VGA_VSYNC, HSYNC with max drive strength */ 147 MX53_PAD_EIM_CS1__IPU_DI1_PIN6 0xe6 148 MX53_PAD_EIM_DA15__IPU_DI1_PIN4 0xe6 149 >; 150 }; 151 }; 152}; 153 154&ipu_di1_disp1 { 155 remote-endpoint = <&display1_in>; 156}; 157 158&cspi { 159 status = "okay"; 160}; 161 162&audmux { 163 status = "okay"; 164 pinctrl-names = "default"; 165 pinctrl-0 = <&pinctrl_audmux>; 166}; 167 168&i2c2 { 169 codec: sgtl5000@a { 170 compatible = "fsl,sgtl5000"; 171 reg = <0x0a>; 172 clocks = <&clks IMX5_CLK_SSI_EXT1_GATE>; 173 VDDA-supply = <®_3p2v>; 174 VDDIO-supply = <®_3p2v>; 175 }; 176 177 expander: pca9554@20 { 178 compatible = "pca9554"; 179 reg = <0x20>; 180 interrupts = <109>; 181 #gpio-cells = <2>; 182 gpio-controller; 183 }; 184 185 sensor2: lm75@49 { 186 compatible = "lm75"; 187 reg = <0x49>; 188 }; 189}; 190 191&fec { 192 phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>; 193 status = "okay"; 194}; 195 196&esdhc2 { 197 status = "okay"; 198}; 199 200&uart3 { 201 status = "okay"; 202}; 203 204&ecspi1 { 205 status = "okay"; 206}; 207 208&usbotg { 209 dr_mode = "host"; 210 status = "okay"; 211}; 212 213&usbh1 { 214 status = "okay"; 215}; 216 217&uart1 { 218 status = "okay"; 219}; 220 221&ssi2 { 222 status = "okay"; 223}; 224 225&uart2 { 226 status = "okay"; 227}; 228 229&can1 { 230 status = "okay"; 231}; 232 233&can2 { 234 status = "okay"; 235}; 236 237&i2c3 { 238 status = "okay"; 239}; 240 241&tve { 242 pinctrl-names = "default"; 243 pinctrl-0 = <&pinctrl_vga_sync_1>; 244 ddc-i2c-bus = <&i2c3>; 245 fsl,tve-mode = "vga"; 246 fsl,hsync-pin = <4>; 247 fsl,vsync-pin = <6>; 248 status = "okay"; 249};