spear1340.dtsi (3780B)
1// SPDX-License-Identifier: GPL-2.0-or-later 2/* 3 * DTS file for all SPEAr1340 SoCs 4 * 5 * Copyright 2012 Viresh Kumar <vireshk@kernel.org> 6 */ 7 8/include/ "spear13xx.dtsi" 9 10/ { 11 compatible = "st,spear1340"; 12 13 ahb { 14 15 spics: spics@e0700000{ 16 compatible = "st,spear-spics-gpio"; 17 reg = <0xe0700000 0x1000>; 18 st-spics,peripcfg-reg = <0x42c>; 19 st-spics,sw-enable-bit = <21>; 20 st-spics,cs-value-bit = <20>; 21 st-spics,cs-enable-mask = <3>; 22 st-spics,cs-enable-shift = <18>; 23 gpio-controller; 24 #gpio-cells = <2>; 25 status = "disabled"; 26 }; 27 28 miphy0: miphy@eb800000 { 29 compatible = "st,spear1340-miphy"; 30 reg = <0xeb800000 0x4000>; 31 misc = <&misc>; 32 #phy-cells = <1>; 33 status = "disabled"; 34 }; 35 36 ahci0: ahci@b1000000 { 37 compatible = "snps,spear-ahci"; 38 reg = <0xb1000000 0x10000>; 39 interrupts = <0 72 0x4>; 40 phys = <&miphy0 0>; 41 phy-names = "sata-phy"; 42 status = "disabled"; 43 }; 44 45 pcie0: pcie@b1000000 { 46 compatible = "st,spear1340-pcie", "snps,dw-pcie"; 47 reg = <0xb1000000 0x4000>, <0x80000000 0x20000>; 48 reg-names = "dbi", "config"; 49 interrupts = <0 68 0x4>; 50 num-lanes = <1>; 51 phys = <&miphy0 1>; 52 phy-names = "pcie-phy"; 53 #address-cells = <3>; 54 #size-cells = <2>; 55 device_type = "pci"; 56 ranges = <0x81000000 0 0 0x80020000 0 0x00010000 /* downstream I/O */ 57 0x82000000 0 0x80030000 0xc0030000 0 0x0ffd0000>; /* non-prefetchable memory */ 58 bus-range = <0x00 0xff>; 59 status = "disabled"; 60 }; 61 62 i2s-play@b2400000 { 63 compatible = "snps,designware-i2s"; 64 reg = <0xb2400000 0x10000>; 65 interrupt-names = "play_irq"; 66 interrupts = <0 98 0x4 67 0 99 0x4>; 68 play; 69 channel = <8>; 70 status = "disabled"; 71 }; 72 73 i2s-rec@b2000000 { 74 compatible = "snps,designware-i2s"; 75 reg = <0xb2000000 0x10000>; 76 interrupt-names = "record_irq"; 77 interrupts = <0 100 0x4 78 0 101 0x4>; 79 record; 80 channel = <8>; 81 status = "disabled"; 82 }; 83 84 pinmux: pinmux@e0700000 { 85 compatible = "st,spear1340-pinmux"; 86 reg = <0xe0700000 0x1000>; 87 #gpio-range-cells = <3>; 88 }; 89 90 pwm: pwm@e0180000 { 91 compatible ="st,spear13xx-pwm"; 92 reg = <0xe0180000 0x1000>; 93 #pwm-cells = <2>; 94 status = "disabled"; 95 }; 96 97 spdif-in@d0100000 { 98 compatible = "st,spdif-in"; 99 reg = < 0xd0100000 0x20000 100 0xd0110000 0x10000 >; 101 interrupts = <0 84 0x4>; 102 status = "disabled"; 103 }; 104 105 spdif-out@d0000000 { 106 compatible = "st,spdif-out"; 107 reg = <0xd0000000 0x20000>; 108 interrupts = <0 85 0x4>; 109 status = "disabled"; 110 }; 111 112 spi1: spi@5d400000 { 113 compatible = "arm,pl022", "arm,primecell"; 114 reg = <0x5d400000 0x1000>; 115 #address-cells = <1>; 116 #size-cells = <0>; 117 interrupts = <0 99 0x4>; 118 status = "disabled"; 119 }; 120 121 apb { 122 i2c1: i2c@b4000000 { 123 #address-cells = <1>; 124 #size-cells = <0>; 125 compatible = "snps,designware-i2c"; 126 reg = <0xb4000000 0x1000>; 127 interrupts = <0 104 0x4>; 128 write-16bit; 129 status = "disabled"; 130 }; 131 132 serial@b4100000 { 133 compatible = "arm,pl011", "arm,primecell"; 134 reg = <0xb4100000 0x1000>; 135 interrupts = <0 105 0x4>; 136 status = "disabled"; 137 dmas = <&dwdma0 13 0 1>, 138 <&dwdma0 12 1 0>; 139 dma-names = "rx", "tx"; 140 }; 141 142 thermal@e07008c4 { 143 st,thermal-flags = <0x2a00>; 144 }; 145 146 gpiopinctrl: gpio@e2800000 { 147 compatible = "st,spear-plgpio"; 148 reg = <0xe2800000 0x1000>; 149 interrupts = <0 107 0x4>; 150 #interrupt-cells = <1>; 151 interrupt-controller; 152 gpio-controller; 153 #gpio-cells = <2>; 154 gpio-ranges = <&pinmux 0 0 252>; 155 status = "disabled"; 156 157 st-plgpio,ngpio = <250>; 158 st-plgpio,wdata-reg = <0x40>; 159 st-plgpio,dir-reg = <0x00>; 160 st-plgpio,ie-reg = <0x80>; 161 st-plgpio,rdata-reg = <0x20>; 162 st-plgpio,mis-reg = <0xa0>; 163 st-plgpio,eit-reg = <0x60>; 164 }; 165 }; 166 }; 167};