pm660.dtsi (4186B)
1// SPDX-License-Identifier: BSD-3-Clause 2/* 3 * Copyright (c) 2020, Konrad Dybcio 4 */ 5 6#include <dt-bindings/iio/qcom,spmi-vadc.h> 7#include <dt-bindings/input/linux-event-codes.h> 8#include <dt-bindings/interrupt-controller/irq.h> 9#include <dt-bindings/spmi/spmi.h> 10#include <dt-bindings/thermal/thermal.h> 11 12/ { 13 thermal-zones { 14 pm660 { 15 polling-delay-passive = <250>; 16 polling-delay = <1000>; 17 18 thermal-sensors = <&pm660_temp>; 19 20 trips { 21 pm660_alert0: pm660-alert0 { 22 temperature = <95000>; 23 hysteresis = <2000>; 24 type = "passive"; 25 }; 26 pm660_crit: pm660-crit { 27 temperature = <125000>; 28 hysteresis = <2000>; 29 type = "critical"; 30 }; 31 }; 32 }; 33 }; 34}; 35 36&spmi_bus { 37 38 pmic@0 { 39 compatible = "qcom,pm660", "qcom,spmi-pmic"; 40 reg = <0x0 SPMI_USID>; 41 #address-cells = <1>; 42 #size-cells = <0>; 43 44 rtc@6000 { 45 compatible = "qcom,pm8941-rtc"; 46 reg = <0x6000>, <0x6100>; 47 reg-names = "rtc", "alarm"; 48 interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>; 49 }; 50 51 pon: pon@800 { 52 compatible = "qcom,pm8998-pon"; 53 reg = <0x800>; 54 mode-bootloader = <0x2>; 55 mode-recovery = <0x1>; 56 57 pon_pwrkey: pwrkey { 58 compatible = "qcom,pm8941-pwrkey"; 59 interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>; 60 debounce = <15625>; 61 bias-pull-up; 62 linux,code = <KEY_POWER>; 63 64 status = "disabled"; 65 }; 66 67 pon_resin: resin { 68 compatible = "qcom,pm8941-resin"; 69 interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>; 70 debounce = <15625>; 71 bias-pull-up; 72 73 status = "disabled"; 74 }; 75 }; 76 77 pm660_temp: temp-alarm@2400 { 78 compatible = "qcom,spmi-temp-alarm"; 79 reg = <0x2400>; 80 interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_RISING>; 81 io-channels = <&pm660_adc ADC5_DIE_TEMP>; 82 io-channel-names = "thermal"; 83 #thermal-sensor-cells = <0>; 84 }; 85 86 pm660_adc: adc@3100 { 87 compatible = "qcom,spmi-adc-rev2"; 88 reg = <0x3100>; 89 interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; 90 #address-cells = <1>; 91 #size-cells = <0>; 92 #io-channel-cells = <1>; 93 94 ref_gnd: ref_gnd@0 { 95 reg = <ADC5_REF_GND>; 96 qcom,decimation = <1024>; 97 qcom,pre-scaling = <1 1>; 98 }; 99 100 vref_1p25: vref_1p25@1 { 101 reg = <ADC5_1P25VREF>; 102 qcom,decimation = <1024>; 103 qcom,pre-scaling = <1 1>; 104 }; 105 106 die_temp: die_temp@6 { 107 reg = <ADC5_DIE_TEMP>; 108 qcom,decimation = <1024>; 109 qcom,pre-scaling = <1 1>; 110 }; 111 112 xo_therm: xo_therm@4c { 113 reg = <ADC5_XO_THERM_100K_PU>; 114 qcom,pre-scaling = <1 1>; 115 qcom,decimation = <1024>; 116 qcom,hw-settle-time = <200>; 117 qcom,ratiometric; 118 }; 119 120 msm_therm: msm_therm@4d { 121 reg = <ADC5_AMUX_THM1_100K_PU>; 122 qcom,pre-scaling = <1 1>; 123 qcom,decimation = <1024>; 124 qcom,hw-settle-time = <200>; 125 qcom,ratiometric; 126 }; 127 128 emmc_therm: emmc_therm@4e { 129 reg = <ADC5_AMUX_THM2_100K_PU>; 130 qcom,pre-scaling = <1 1>; 131 qcom,decimation = <1024>; 132 qcom,hw-settle-time = <200>; 133 qcom,ratiometric; 134 }; 135 136 pa_therm0: thermistor0@4f { 137 reg = <ADC5_AMUX_THM3_100K_PU>; 138 qcom,pre-scaling = <1 1>; 139 qcom,decimation = <1024>; 140 qcom,hw-settle-time = <200>; 141 qcom,ratiometric; 142 }; 143 144 pa_therm1: thermistor1@50 { 145 reg = <ADC5_AMUX_THM4_100K_PU>; 146 qcom,pre-scaling = <1 1>; 147 qcom,decimation = <1024>; 148 qcom,hw-settle-time = <200>; 149 qcom,ratiometric; 150 }; 151 152 quiet_therm: quiet_therm@51 { 153 reg = <ADC5_AMUX_THM5_100K_PU>; 154 qcom,pre-scaling = <1 1>; 155 qcom,decimation = <1024>; 156 qcom,hw-settle-time = <200>; 157 qcom,ratiometric; 158 }; 159 160 vadc_vph_pwr: vph_pwr@83 { 161 reg = <ADC5_VPH_PWR>; 162 qcom,decimation = <1024>; 163 qcom,pre-scaling = <1 3>; 164 }; 165 166 vcoin: vcoin@83 { 167 reg = <ADC5_VCOIN>; 168 qcom,decimation = <1024>; 169 qcom,pre-scaling = <1 3>; 170 }; 171 }; 172 173 pm660_gpios: gpios@c000 { 174 compatible = "qcom,pm660-gpio"; 175 reg = <0xc000>; 176 gpio-controller; 177 gpio-ranges = <&pm660_gpios 0 0 13>; 178 #gpio-cells = <2>; 179 interrupt-controller; 180 #interrupt-cells = <2>; 181 }; 182 }; 183 184 pmic@1 { 185 compatible = "qcom,pm660", "qcom,spmi-pmic"; 186 reg = <0x1 SPMI_USID>; 187 #address-cells = <1>; 188 #size-cells = <0>; 189 190 pm660_spmi_regulators: pm660-regulators { 191 compatible = "qcom,pm660-regulators"; 192 }; 193 }; 194};