omap_hwspinlock.c (5109B)
1// SPDX-License-Identifier: GPL-2.0 2/* 3 * OMAP hardware spinlock driver 4 * 5 * Copyright (C) 2010-2021 Texas Instruments Incorporated - https://www.ti.com 6 * 7 * Contact: Simon Que <sque@ti.com> 8 * Hari Kanigeri <h-kanigeri2@ti.com> 9 * Ohad Ben-Cohen <ohad@wizery.com> 10 * Suman Anna <s-anna@ti.com> 11 */ 12 13#include <linux/kernel.h> 14#include <linux/module.h> 15#include <linux/device.h> 16#include <linux/delay.h> 17#include <linux/io.h> 18#include <linux/bitops.h> 19#include <linux/pm_runtime.h> 20#include <linux/slab.h> 21#include <linux/spinlock.h> 22#include <linux/hwspinlock.h> 23#include <linux/of.h> 24#include <linux/platform_device.h> 25 26#include "hwspinlock_internal.h" 27 28/* Spinlock register offsets */ 29#define SYSSTATUS_OFFSET 0x0014 30#define LOCK_BASE_OFFSET 0x0800 31 32#define SPINLOCK_NUMLOCKS_BIT_OFFSET (24) 33 34/* Possible values of SPINLOCK_LOCK_REG */ 35#define SPINLOCK_NOTTAKEN (0) /* free */ 36#define SPINLOCK_TAKEN (1) /* locked */ 37 38static int omap_hwspinlock_trylock(struct hwspinlock *lock) 39{ 40 void __iomem *lock_addr = lock->priv; 41 42 /* attempt to acquire the lock by reading its value */ 43 return (SPINLOCK_NOTTAKEN == readl(lock_addr)); 44} 45 46static void omap_hwspinlock_unlock(struct hwspinlock *lock) 47{ 48 void __iomem *lock_addr = lock->priv; 49 50 /* release the lock by writing 0 to it */ 51 writel(SPINLOCK_NOTTAKEN, lock_addr); 52} 53 54/* 55 * relax the OMAP interconnect while spinning on it. 56 * 57 * The specs recommended that the retry delay time will be 58 * just over half of the time that a requester would be 59 * expected to hold the lock. 60 * 61 * The number below is taken from an hardware specs example, 62 * obviously it is somewhat arbitrary. 63 */ 64static void omap_hwspinlock_relax(struct hwspinlock *lock) 65{ 66 ndelay(50); 67} 68 69static const struct hwspinlock_ops omap_hwspinlock_ops = { 70 .trylock = omap_hwspinlock_trylock, 71 .unlock = omap_hwspinlock_unlock, 72 .relax = omap_hwspinlock_relax, 73}; 74 75static int omap_hwspinlock_probe(struct platform_device *pdev) 76{ 77 struct device_node *node = pdev->dev.of_node; 78 struct hwspinlock_device *bank; 79 struct hwspinlock *hwlock; 80 void __iomem *io_base; 81 int num_locks, i, ret; 82 /* Only a single hwspinlock block device is supported */ 83 int base_id = 0; 84 85 if (!node) 86 return -ENODEV; 87 88 io_base = devm_platform_ioremap_resource(pdev, 0); 89 if (IS_ERR(io_base)) 90 return PTR_ERR(io_base); 91 92 /* 93 * make sure the module is enabled and clocked before reading 94 * the module SYSSTATUS register 95 */ 96 pm_runtime_enable(&pdev->dev); 97 ret = pm_runtime_get_sync(&pdev->dev); 98 if (ret < 0) { 99 pm_runtime_put_noidle(&pdev->dev); 100 goto runtime_err; 101 } 102 103 /* Determine number of locks */ 104 i = readl(io_base + SYSSTATUS_OFFSET); 105 i >>= SPINLOCK_NUMLOCKS_BIT_OFFSET; 106 107 /* 108 * runtime PM will make sure the clock of this module is 109 * enabled again iff at least one lock is requested 110 */ 111 ret = pm_runtime_put(&pdev->dev); 112 if (ret < 0) 113 goto runtime_err; 114 115 /* one of the four lsb's must be set, and nothing else */ 116 if (hweight_long(i & 0xf) != 1 || i > 8) { 117 ret = -EINVAL; 118 goto runtime_err; 119 } 120 121 num_locks = i * 32; /* actual number of locks in this device */ 122 123 bank = devm_kzalloc(&pdev->dev, struct_size(bank, lock, num_locks), 124 GFP_KERNEL); 125 if (!bank) { 126 ret = -ENOMEM; 127 goto runtime_err; 128 } 129 130 platform_set_drvdata(pdev, bank); 131 132 for (i = 0, hwlock = &bank->lock[0]; i < num_locks; i++, hwlock++) 133 hwlock->priv = io_base + LOCK_BASE_OFFSET + sizeof(u32) * i; 134 135 ret = hwspin_lock_register(bank, &pdev->dev, &omap_hwspinlock_ops, 136 base_id, num_locks); 137 if (ret) 138 goto runtime_err; 139 140 dev_dbg(&pdev->dev, "Registered %d locks with HwSpinlock core\n", 141 num_locks); 142 143 return 0; 144 145runtime_err: 146 pm_runtime_disable(&pdev->dev); 147 return ret; 148} 149 150static int omap_hwspinlock_remove(struct platform_device *pdev) 151{ 152 struct hwspinlock_device *bank = platform_get_drvdata(pdev); 153 int ret; 154 155 ret = hwspin_lock_unregister(bank); 156 if (ret) { 157 dev_err(&pdev->dev, "%s failed: %d\n", __func__, ret); 158 return ret; 159 } 160 161 pm_runtime_disable(&pdev->dev); 162 163 return 0; 164} 165 166static const struct of_device_id omap_hwspinlock_of_match[] = { 167 { .compatible = "ti,omap4-hwspinlock", }, 168 { .compatible = "ti,am64-hwspinlock", }, 169 { .compatible = "ti,am654-hwspinlock", }, 170 { /* end */ }, 171}; 172MODULE_DEVICE_TABLE(of, omap_hwspinlock_of_match); 173 174static struct platform_driver omap_hwspinlock_driver = { 175 .probe = omap_hwspinlock_probe, 176 .remove = omap_hwspinlock_remove, 177 .driver = { 178 .name = "omap_hwspinlock", 179 .of_match_table = of_match_ptr(omap_hwspinlock_of_match), 180 }, 181}; 182 183static int __init omap_hwspinlock_init(void) 184{ 185 return platform_driver_register(&omap_hwspinlock_driver); 186} 187/* board init code might need to reserve hwspinlocks for predefined purposes */ 188postcore_initcall(omap_hwspinlock_init); 189 190static void __exit omap_hwspinlock_exit(void) 191{ 192 platform_driver_unregister(&omap_hwspinlock_driver); 193} 194module_exit(omap_hwspinlock_exit); 195 196MODULE_LICENSE("GPL v2"); 197MODULE_DESCRIPTION("Hardware spinlock driver for OMAP"); 198MODULE_AUTHOR("Simon Que <sque@ti.com>"); 199MODULE_AUTHOR("Hari Kanigeri <h-kanigeri2@ti.com>"); 200MODULE_AUTHOR("Ohad Ben-Cohen <ohad@wizery.com>");