Kconfig (1898B)
1# SPDX-License-Identifier: GPL-2.0-only 2# 3# Qualcomm network device configuration 4# 5 6config NET_VENDOR_QUALCOMM 7 bool "Qualcomm devices" 8 default y 9 help 10 If you have a network (Ethernet) card belonging to this class, say Y. 11 12 Note that the answer to this question doesn't directly affect the 13 kernel: saying N will just cause the configurator to skip all 14 the questions about Qualcomm cards. If you say Y, you will be asked 15 for your specific card in the following questions. 16 17if NET_VENDOR_QUALCOMM 18 19config QCA7000 20 tristate 21 help 22 This enables support for the Qualcomm Atheros QCA7000. 23 24config QCA7000_SPI 25 tristate "Qualcomm Atheros QCA7000 SPI support" 26 select QCA7000 27 depends on SPI_MASTER && OF 28 help 29 This SPI protocol driver supports the Qualcomm Atheros QCA7000. 30 31 To compile this driver as a module, choose M here. The module 32 will be called qcaspi. 33 34config QCA7000_UART 35 tristate "Qualcomm Atheros QCA7000 UART support" 36 select QCA7000 37 depends on SERIAL_DEV_BUS && OF 38 help 39 This UART protocol driver supports the Qualcomm Atheros QCA7000. 40 41 Currently the driver assumes these device UART settings: 42 Data bits: 8 43 Parity: None 44 Stop bits: 1 45 Flow control: None 46 47 To compile this driver as a module, choose M here. The module 48 will be called qcauart. 49 50config QCOM_EMAC 51 tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support" 52 depends on HAS_DMA && HAS_IOMEM 53 select CRC32 54 select PHYLIB 55 help 56 This driver supports the Qualcomm Technologies, Inc. Gigabit 57 Ethernet Media Access Controller (EMAC). The controller 58 supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s, 59 full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for 60 low power, Receive-Side Scaling (RSS), and IEEE 1588-2008 61 Precision Clock Synchronization Protocol. 62 63source "drivers/net/ethernet/qualcomm/rmnet/Kconfig" 64 65endif # NET_VENDOR_QUALCOMM