config.h (3624B)
1/* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */ 2/* 3 * Copyright (C) 2012-2014, 2018-2019 Intel Corporation 4 * Copyright (C) 2013-2015 Intel Mobile Communications GmbH 5 * Copyright (C) 2016-2017 Intel Deutschland GmbH 6 */ 7#ifndef __iwl_fw_api_config_h__ 8#define __iwl_fw_api_config_h__ 9 10/* 11 * struct iwl_dqa_enable_cmd 12 * @cmd_queue: the TXQ number of the command queue 13 */ 14struct iwl_dqa_enable_cmd { 15 __le32 cmd_queue; 16} __packed; /* DQA_CONTROL_CMD_API_S_VER_1 */ 17 18/* 19 * struct iwl_tx_ant_cfg_cmd 20 * @valid: valid antenna configuration 21 */ 22struct iwl_tx_ant_cfg_cmd { 23 __le32 valid; 24} __packed; 25 26/** 27 * struct iwl_calib_ctrl - Calibration control struct. 28 * Sent as part of the phy configuration command. 29 * @flow_trigger: bitmap for which calibrations to perform according to 30 * flow triggers, using &enum iwl_calib_cfg 31 * @event_trigger: bitmap for which calibrations to perform according to 32 * event triggers, using &enum iwl_calib_cfg 33 */ 34struct iwl_calib_ctrl { 35 __le32 flow_trigger; 36 __le32 event_trigger; 37} __packed; 38 39/* This enum defines the bitmap of various calibrations to enable in both 40 * init ucode and runtime ucode through CALIBRATION_CFG_CMD. 41 */ 42enum iwl_calib_cfg { 43 IWL_CALIB_CFG_XTAL_IDX = BIT(0), 44 IWL_CALIB_CFG_TEMPERATURE_IDX = BIT(1), 45 IWL_CALIB_CFG_VOLTAGE_READ_IDX = BIT(2), 46 IWL_CALIB_CFG_PAPD_IDX = BIT(3), 47 IWL_CALIB_CFG_TX_PWR_IDX = BIT(4), 48 IWL_CALIB_CFG_DC_IDX = BIT(5), 49 IWL_CALIB_CFG_BB_FILTER_IDX = BIT(6), 50 IWL_CALIB_CFG_LO_LEAKAGE_IDX = BIT(7), 51 IWL_CALIB_CFG_TX_IQ_IDX = BIT(8), 52 IWL_CALIB_CFG_TX_IQ_SKEW_IDX = BIT(9), 53 IWL_CALIB_CFG_RX_IQ_IDX = BIT(10), 54 IWL_CALIB_CFG_RX_IQ_SKEW_IDX = BIT(11), 55 IWL_CALIB_CFG_SENSITIVITY_IDX = BIT(12), 56 IWL_CALIB_CFG_CHAIN_NOISE_IDX = BIT(13), 57 IWL_CALIB_CFG_DISCONNECTED_ANT_IDX = BIT(14), 58 IWL_CALIB_CFG_ANT_COUPLING_IDX = BIT(15), 59 IWL_CALIB_CFG_DAC_IDX = BIT(16), 60 IWL_CALIB_CFG_ABS_IDX = BIT(17), 61 IWL_CALIB_CFG_AGC_IDX = BIT(18), 62}; 63 64/** 65 * struct iwl_phy_specific_cfg - specific PHY filter configuration 66 * 67 * Sent as part of the phy configuration command (v3) to configure specific FW 68 * defined PHY filters that can be applied to each antenna. 69 * 70 * @filter_cfg_chain_a: filter config id for LMAC1 chain A 71 * @filter_cfg_chain_b: filter config id for LMAC1 chain B 72 * @filter_cfg_chain_c: filter config id for LMAC2 chain A 73 * @filter_cfg_chain_d: filter config id for LMAC2 chain B 74 * values: 0 - no filter; 0xffffffff - reserved; otherwise - filter id 75 */ 76struct iwl_phy_specific_cfg { 77 __le32 filter_cfg_chain_a; 78 __le32 filter_cfg_chain_b; 79 __le32 filter_cfg_chain_c; 80 __le32 filter_cfg_chain_d; 81} __packed; /* PHY_SPECIFIC_CONFIGURATION_API_VER_1*/ 82 83/** 84 * struct iwl_phy_cfg_cmd - Phy configuration command 85 * 86 * @phy_cfg: PHY configuration value, uses &enum iwl_fw_phy_cfg 87 * @calib_control: calibration control data 88 */ 89struct iwl_phy_cfg_cmd_v1 { 90 __le32 phy_cfg; 91 struct iwl_calib_ctrl calib_control; 92} __packed; 93 94/** 95 * struct iwl_phy_cfg_cmd_v3 - Phy configuration command (v3) 96 * 97 * @phy_cfg: PHY configuration value, uses &enum iwl_fw_phy_cfg 98 * @calib_control: calibration control data 99 * @phy_specific_cfg: configure predefined PHY filters 100 */ 101struct iwl_phy_cfg_cmd_v3 { 102 __le32 phy_cfg; 103 struct iwl_calib_ctrl calib_control; 104 struct iwl_phy_specific_cfg phy_specific_cfg; 105} __packed; /* PHY_CONFIGURATION_CMD_API_S_VER_3 */ 106 107/* 108 * enum iwl_dc2dc_config_id - flag ids 109 * 110 * Ids of dc2dc configuration flags 111 */ 112enum iwl_dc2dc_config_id { 113 DCDC_LOW_POWER_MODE_MSK_SET = 0x1, /* not used */ 114 DCDC_FREQ_TUNE_SET = 0x2, 115}; /* MARKER_ID_API_E_VER_1 */ 116 117#endif /* __iwl_fw_api_config_h__ */