Merge drm/drm-fixes into drm-misc-fixes

Start this new release drm-misc-fixes branch

Signed-off-by: Maxime Ripard <maxime@cerno.tech>

1 files changed, 6 insertions, 4 deletions

diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index 6aeb711f7cd1..e18ab3d5908f 100644
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -76,10 +76,11 @@ struct pinctrl_map;
  * @PIN_CONFIG_INPUT_SCHMITT_ENABLE: control schmitt-trigger mode on the pin.
  *      If the argument != 0, schmitt-trigger mode is enabled. If it's 0,
  *      schmitt-trigger mode is disabled.
- * @PIN_CONFIG_LOW_POWER_MODE: this will configure the pin for low power
+ * @PIN_CONFIG_MODE_LOW_POWER: this will configure the pin for low power
  *	operation, if several modes of operation are supported these can be
  *	passed in the argument on a custom form, else just use argument 1
  *	to indicate low power mode, argument 0 turns low power mode off.
+ * @PIN_CONFIG_MODE_PWM: this will configure the pin for PWM
  * @PIN_CONFIG_OUTPUT_ENABLE: this will enable the pin's output mode
  * 	without driving a value there. For most platforms this reduces to
  * 	enable the output buffers and then let the pin controller current
@@ -90,6 +91,7 @@ struct pinctrl_map;
  * 	value on the line. Use argument 1 to indicate high level, argument 0 to
  *	indicate low level. (Please see Documentation/driver-api/pinctl.rst,
  *	section "GPIO mode pitfalls" for a discussion around this parameter.)
+ * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset
  * @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power
  *	supplies, the argument to this parameter (on a custom format) tells
  *	the driver which alternative power source to use.
@@ -101,7 +103,6 @@ struct pinctrl_map;
  *	or latch delay (on outputs) this parameter (in a custom format)
  *	specifies the clock skew or latch delay. It typically controls how
  *	many double inverters are put in front of the line.
- * @PIN_CONFIG_PERSIST_STATE: retain pin state across sleep or controller reset
  * @PIN_CONFIG_END: this is the last enumerator for pin configurations, if
  *	you need to pass in custom configurations to the pin controller, use
  *	PIN_CONFIG_END+1 as the base offset.
@@ -124,14 +125,15 @@ enum pin_config_param {
 	PIN_CONFIG_INPUT_ENABLE,
 	PIN_CONFIG_INPUT_SCHMITT,
 	PIN_CONFIG_INPUT_SCHMITT_ENABLE,
-	PIN_CONFIG_LOW_POWER_MODE,
+	PIN_CONFIG_MODE_LOW_POWER,
+	PIN_CONFIG_MODE_PWM,
 	PIN_CONFIG_OUTPUT_ENABLE,
 	PIN_CONFIG_OUTPUT,
+	PIN_CONFIG_PERSIST_STATE,
 	PIN_CONFIG_POWER_SOURCE,
 	PIN_CONFIG_SLEEP_HARDWARE_STATE,
 	PIN_CONFIG_SLEW_RATE,
 	PIN_CONFIG_SKEW_DELAY,
-	PIN_CONFIG_PERSIST_STATE,
 	PIN_CONFIG_END = 0x7F,
 	PIN_CONFIG_MAX = 0xFF,
 };