diff options
Diffstat (limited to 'include/linux')
| -rw-r--r-- | include/linux/soundwire/sdw.h | 274 |
1 files changed, 274 insertions, 0 deletions
diff --git a/include/linux/soundwire/sdw.h b/include/linux/soundwire/sdw.h index 3bfa7f1e2b47..3c13f580d42d 100644 --- a/include/linux/soundwire/sdw.h +++ b/include/linux/soundwire/sdw.h @@ -39,6 +39,252 @@ enum sdw_slave_status { }; /* + * SDW properties, defined in MIPI DisCo spec v1.0 + */ +enum sdw_clk_stop_reset_behave { + SDW_CLK_STOP_KEEP_STATUS = 1, +}; + +/** + * enum sdw_p15_behave - Slave Port 15 behaviour when the Master attempts a + * read + * @SDW_P15_READ_IGNORED: Read is ignored + * @SDW_P15_CMD_OK: Command is ok + */ +enum sdw_p15_behave { + SDW_P15_READ_IGNORED = 0, + SDW_P15_CMD_OK = 1, +}; + +/** + * enum sdw_dpn_type - Data port types + * @SDW_DPN_FULL: Full Data Port is supported + * @SDW_DPN_SIMPLE: Simplified Data Port as defined in spec. + * DPN_SampleCtrl2, DPN_OffsetCtrl2, DPN_HCtrl and DPN_BlockCtrl3 + * are not implemented. + * @SDW_DPN_REDUCED: Reduced Data Port as defined in spec. + * DPN_SampleCtrl2, DPN_HCtrl are not implemented. + */ +enum sdw_dpn_type { + SDW_DPN_FULL = 0, + SDW_DPN_SIMPLE = 1, + SDW_DPN_REDUCED = 2, +}; + +/** + * enum sdw_clk_stop_mode - Clock Stop modes + * @SDW_CLK_STOP_MODE0: Slave can continue operation seamlessly on clock + * restart + * @SDW_CLK_STOP_MODE1: Slave may have entered a deeper power-saving mode, + * not capable of continuing operation seamlessly when the clock restarts + */ +enum sdw_clk_stop_mode { + SDW_CLK_STOP_MODE0 = 0, + SDW_CLK_STOP_MODE1 = 1, +}; + +/** + * struct sdw_dp0_prop - DP0 properties + * @max_word: Maximum number of bits in a Payload Channel Sample, 1 to 64 + * (inclusive) + * @min_word: Minimum number of bits in a Payload Channel Sample, 1 to 64 + * (inclusive) + * @num_words: number of wordlengths supported + * @words: wordlengths supported + * @flow_controlled: Slave implementation results in an OK_NotReady + * response + * @simple_ch_prep_sm: If channel prepare sequence is required + * @device_interrupts: If implementation-defined interrupts are supported + * + * The wordlengths are specified by Spec as max, min AND number of + * discrete values, implementation can define based on the wordlengths they + * support + */ +struct sdw_dp0_prop { + u32 max_word; + u32 min_word; + u32 num_words; + u32 *words; + bool flow_controlled; + bool simple_ch_prep_sm; + bool device_interrupts; +}; + +/** + * struct sdw_dpn_audio_mode - Audio mode properties for DPn + * @bus_min_freq: Minimum bus frequency, in Hz + * @bus_max_freq: Maximum bus frequency, in Hz + * @bus_num_freq: Number of discrete frequencies supported + * @bus_freq: Discrete bus frequencies, in Hz + * @min_freq: Minimum sampling frequency, in Hz + * @max_freq: Maximum sampling bus frequency, in Hz + * @num_freq: Number of discrete sampling frequency supported + * @freq: Discrete sampling frequencies, in Hz + * @prep_ch_behave: Specifies the dependencies between Channel Prepare + * sequence and bus clock configuration + * If 0, Channel Prepare can happen at any Bus clock rate + * If 1, Channel Prepare sequence shall happen only after Bus clock is + * changed to a frequency supported by this mode or compatible modes + * described by the next field + * @glitchless: Bitmap describing possible glitchless transitions from this + * Audio Mode to other Audio Modes + */ +struct sdw_dpn_audio_mode { + u32 bus_min_freq; + u32 bus_max_freq; + u32 bus_num_freq; + u32 *bus_freq; + u32 max_freq; + u32 min_freq; + u32 num_freq; + u32 *freq; + u32 prep_ch_behave; + u32 glitchless; +}; + +/** + * struct sdw_dpn_prop - Data Port DPn properties + * @num: port number + * @max_word: Maximum number of bits in a Payload Channel Sample, 1 to 64 + * (inclusive) + * @min_word: Minimum number of bits in a Payload Channel Sample, 1 to 64 + * (inclusive) + * @num_words: Number of discrete supported wordlengths + * @words: Discrete supported wordlength + * @type: Data port type. Full, Simplified or Reduced + * @max_grouping: Maximum number of samples that can be grouped together for + * a full data port + * @simple_ch_prep_sm: If the port supports simplified channel prepare state + * machine + * @ch_prep_timeout: Port-specific timeout value, in milliseconds + * @device_interrupts: If set, each bit corresponds to support for + * implementation-defined interrupts + * @max_ch: Maximum channels supported + * @min_ch: Minimum channels supported + * @num_ch: Number of discrete channels supported + * @ch: Discrete channels supported + * @num_ch_combinations: Number of channel combinations supported + * @ch_combinations: Channel combinations supported + * @modes: SDW mode supported + * @max_async_buffer: Number of samples that this port can buffer in + * asynchronous modes + * @block_pack_mode: Type of block port mode supported + * @port_encoding: Payload Channel Sample encoding schemes supported + * @audio_modes: Audio modes supported + */ +struct sdw_dpn_prop { + u32 num; + u32 max_word; + u32 min_word; + u32 num_words; + u32 *words; + enum sdw_dpn_type type; + u32 max_grouping; + bool simple_ch_prep_sm; + u32 ch_prep_timeout; + u32 device_interrupts; + u32 max_ch; + u32 min_ch; + u32 num_ch; + u32 *ch; + u32 num_ch_combinations; + u32 *ch_combinations; + u32 modes; + u32 max_async_buffer; + bool block_pack_mode; + u32 port_encoding; + struct sdw_dpn_audio_mode *audio_modes; +}; + +/** + * struct sdw_slave_prop - SoundWire Slave properties + * @mipi_revision: Spec version of the implementation + * @wake_capable: Wake-up events are supported + * @test_mode_capable: If test mode is supported + * @clk_stop_mode1: Clock-Stop Mode 1 is supported + * @simple_clk_stop_capable: Simple clock mode is supported + * @clk_stop_timeout: Worst-case latency of the Clock Stop Prepare State + * Machine transitions, in milliseconds + * @ch_prep_timeout: Worst-case latency of the Channel Prepare State Machine + * transitions, in milliseconds + * @reset_behave: Slave keeps the status of the SlaveStopClockPrepare + * state machine (P=1 SCSP_SM) after exit from clock-stop mode1 + * @high_PHY_capable: Slave is HighPHY capable + * @paging_support: Slave implements paging registers SCP_AddrPage1 and + * SCP_AddrPage2 + * @bank_delay_support: Slave implements bank delay/bridge support registers + * SCP_BankDelay and SCP_NextFrame + * @p15_behave: Slave behavior when the Master attempts a read to the Port15 + * alias + * @lane_control_support: Slave supports lane control + * @master_count: Number of Masters present on this Slave + * @source_ports: Bitmap identifying source ports + * @sink_ports: Bitmap identifying sink ports + * @dp0_prop: Data Port 0 properties + * @src_dpn_prop: Source Data Port N properties + * @sink_dpn_prop: Sink Data Port N properties + */ +struct sdw_slave_prop { + u32 mipi_revision; + bool wake_capable; + bool test_mode_capable; + bool clk_stop_mode1; + bool simple_clk_stop_capable; + u32 clk_stop_timeout; + u32 ch_prep_timeout; + enum sdw_clk_stop_reset_behave reset_behave; + bool high_PHY_capable; + bool paging_support; + bool bank_delay_support; + enum sdw_p15_behave p15_behave; + bool lane_control_support; + u32 master_count; + u32 source_ports; + u32 sink_ports; + struct sdw_dp0_prop *dp0_prop; + struct sdw_dpn_prop *src_dpn_prop; + struct sdw_dpn_prop *sink_dpn_prop; +}; + +/** + * struct sdw_master_prop - Master properties + * @revision: MIPI spec version of the implementation + * @master_count: Number of masters + * @clk_stop_mode: Bitmap for Clock Stop modes supported + * @max_freq: Maximum Bus clock frequency, in Hz + * @num_clk_gears: Number of clock gears supported + * @clk_gears: Clock gears supported + * @num_freq: Number of clock frequencies supported, in Hz + * @freq: Clock frequencies supported, in Hz + * @default_frame_rate: Controller default Frame rate, in Hz + * @default_row: Number of rows + * @default_col: Number of columns + * @dynamic_frame: Dynamic frame supported + * @err_threshold: Number of times that software may retry sending a single + * command + * @dpn_prop: Data Port N properties + */ +struct sdw_master_prop { + u32 revision; + u32 master_count; + enum sdw_clk_stop_mode clk_stop_mode; + u32 max_freq; + u32 num_clk_gears; + u32 *clk_gears; + u32 num_freq; + u32 *freq; + u32 default_frame_rate; + u32 default_row; + u32 default_col; + bool dynamic_frame; + u32 err_threshold; + struct sdw_dpn_prop *dpn_prop; +}; + +int sdw_master_read_prop(struct sdw_bus *bus); +int sdw_slave_read_prop(struct sdw_slave *slave); + +/* * SDW Slave Structures and APIs */ @@ -62,12 +308,23 @@ struct sdw_slave_id { }; /** + * struct sdw_slave_ops - Slave driver callback ops + * @read_prop: Read Slave properties + */ +struct sdw_slave_ops { + int (*read_prop)(struct sdw_slave *sdw); +}; + +/** * struct sdw_slave - SoundWire Slave * @id: MIPI device ID * @dev: Linux device * @status: Status reported by the Slave * @bus: Bus handle + * @ops: Slave callback ops + * @prop: Slave properties * @node: node for bus list + * @port_ready: Port ready completion flag for each Slave port * @dev_num: Device Number assigned by Bus */ struct sdw_slave { @@ -75,7 +332,10 @@ struct sdw_slave { struct device dev; enum sdw_slave_status status; struct sdw_bus *bus; + const struct sdw_slave_ops *ops; + struct sdw_slave_prop prop; struct list_head node; + struct completion *port_ready; u16 dev_num; }; @@ -104,6 +364,14 @@ struct sdw_driver { */ /** + * struct sdw_master_ops - Master driver ops + * @read_prop: Read Master properties + */ +struct sdw_master_ops { + int (*read_prop)(struct sdw_bus *bus); +}; + +/** * struct sdw_bus - SoundWire bus * @dev: Master linux device * @link_id: Link id number, can be 0 to N, unique for each Master @@ -111,6 +379,9 @@ struct sdw_driver { * @assigned: Bitmap for Slave device numbers. * Bit set implies used number, bit clear implies unused number. * @bus_lock: bus lock + * @ops: Master callback ops + * @prop: Master properties + * @clk_stop_timeout: Clock stop timeout computed */ struct sdw_bus { struct device *dev; @@ -118,6 +389,9 @@ struct sdw_bus { struct list_head slaves; DECLARE_BITMAP(assigned, SDW_MAX_DEVICES); struct mutex bus_lock; + const struct sdw_master_ops *ops; + struct sdw_master_prop prop; + unsigned int clk_stop_timeout; }; int sdw_add_bus_master(struct sdw_bus *bus); |